Taiwan vertical car_Oil engine vertical carIs a kind of vertical lathe,Oil engine vertical carThere are usually two types, one is single-column type and the other is double-column type.Oil engine vertical carThe main feature of the lathe structure is that its spindle is in a vertical position.Oil engine vertical carThe operating procedures in the operation work are very important. When the equipment is running, the operator must strictly abide by the operating procedures of the workshop. So...Oil engine vertical carWhat operations need to be done carefully in the work? The following is a brief introduction for everyone.

Taiwan vertical car_oil engine vertical carA brief introduction to the operating procedures:

（1) The rough surface of the workpiece is not allowed to be directly placed onOil engine vertical carofOn the work surface, pad iron or screw top support should be used; it is strictly prohibited to use the work surface for other operations Such as the use of hammer correction workpiece, welding workpiece and so on.

（2) When the workpiece is to be found, the worktable can only be inched for low-speed rotation, and high-speed correction is not allowed.

（32) When the working platform is started and stopped,Oil engine vertical carThe opening and stopping handle of the workbench can only be pulled by hand, and pedals are strictly prohibited.

（42) When the workbench is rotating, it is not allowed to do lifting of the crossbeam and rapid movement of the tool holder.

（54) When moving the beam, the clamping device must be loosened first, and the beam shall be clamped immediately after the movement.Oil engine vertical carAfter each drop of the beam, it should rise a little to eliminate the gap between the lead screw and the nut.

（6) Hanging is not allowedOil engine vertical carWhen the ram of the tool holder and the side tool holder extends for a long time, the gravity cutting is carried out. The vertical tool holder is used for processing, especially when gravity cutting, the beams should be lowered as close as possible to the working position.

（7) When making intermittent cutting, it should be appropriately reduced.Oil engine vertical caroffeed rate and table speed.

（8) The lever must be pushed to the specified position when shifting. If the gear is not meshed properly, it should be adjusted by micro-movement after work, and it is not allowed to force the worker table.“On/Off”Handle.

Oil engine vertical carin the course of work, There are two vertical tool post machine tools, the vertical tool post should be symmetrically stopped at both ends of the beam; there is a vertical tool post machine tool, the verticalofThe tool holder stops in the middle of the beam; the side tool holder should be moved to the lower end of the column.