Small CNC vertical latheOperating procedures:

1. It is not allowed to place the rough surface of the workpiece directly on the surface of the workpiece, but use angle iron or screw top to support it. It is strictly forbidden to use the work surface for other operations, such as correcting the workpiece by hammering, welding, etc.

2. When aligning the workpiece, the worktable can only be moved at low speed to align the workpiece, but not at high speed.

3. When opening and stopping the workbench, you can only pull the handle of the workbench by hand, and it is strictly forbidden to step on it.

4. When the worktable rotates, the lifting of the beam and the rapid movement of the tool holder are not allowed.

5. When moving the beam, the clamping device must be loosened first. After moving, the beam should be clamped immediately. After each drop, it should rise a little to eliminate the gap between the screw nut.

6. It is not allowed to carry out gravity cutting when the ram of the straight tool holder and the side tool holder is extended for a long time. When using a vertical tool holder for machining, especially for gravity cutting, the beams should be lowered as close as possible to the working position.

7. When performing intermittent cutting, it is necessary to appropriately reduce the feed rate and the speed of the worktable.

8. The operating lever must be pushed to the specified position during speed change. If the gear is not meshed properly, it should be adjusted by micro-movement after work. It is not allowed to force the "start and stop" handle of the worker table.

In addition to regular operations, also know:

Small CNC vertical latheThe maintenance and use of attention:

1, strictly abide by the operating procedures and daily maintenance system.

2. Prevent dust from entering the electronic control equipment. Floating dust and metal powder may cause the insulation resistance between electrical components to decrease, resulting in component damage or even damage.

3. Regularly clean the cooling and ventilation system of the electric control cabinet.

4. The use environment of the small CNC vertical lathe, it is best to place the small CNC vertical lathe in a constant temperature environment, and stay away from the equipment with large vibration (such as punching machine) and electromagnetic interference equipment.

5, small CNC vertical car should have operating procedures for regular maintenance, maintenance. In case of failure, pay attention to record and protect the site.

6, small CNC vertical car should not be stored for a long time.

7, pay attention to training, and equipped with operators and maintenance personnel.