CNC vertical latheNote for operators:

1. All operators shall be professionally trained and evaluated. After passing the assessment, they can take up positions and operate machines.

2. Before operating the machine, the operator should be familiar with and understand the structure and performance of the machine.

3. Before use, the machine must be lubricated, some components must be cleaned, and the oil passage must be kept unblocked.

4, CNC vertical lathe to check the various parts, and then let the machine idle run about 10 min, check whether there is any abnormal, if there is no problem, then you can start to work.

5. During the operation of the machine, once an abnormality is found, it should be turned off for inspection.

6. The clamping of the tool must be correct and must be tightened without loosening. It is strictly forbidden to use tools for cutting to avoid damage to the tools.

7. The balance spring device on the tool holder can work normally. The spring must not be adjusted without authorization to avoid problems.

8. When the workbench is running, its speed and running direction are not allowed to change, and reverse braking is not allowed. If you want to run at high speed, you must add a protective cover.

9, CNC vertical lathe work process, the operator can not leave without authorization, if you need to leave, then you should first stop and turn off the power switch, and then leave.

10,CNC vertical latheAfter the work is completed, the equipment and site shall be cleaned. The operating handle of the machine should be placed in neutral, and cut off the power supply, but also the machine for daily lubrication and maintenance work.

11. It is forbidden to store any items in the protective door or electrical cabinet.

12. Without the permission of the equipment authority, the machine tool parts cannot be added or disassembled separately, nor can the key parts of the machine tool be disassembled and disassembled separately.

13. It is strictly forbidden to use machine tools that exceed specifications and overload.

14, safe and civilized production, and abide by the relevant provisions.

15. Each shift should add oil to the hydraulic oil tank, lubricating oil tank and coolant tank to the oil standard level. Before leaving work, the guide rail surface and fixture should be cleaned to remove iron filings and dirt, and oil should be applied to each sliding surface.

16, check the need to use the work, cards, measuring tools should be complete and intact. The blank parts to be processed shall meet the process requirements, and the parts drawings and relevant technical documents to be processed shall be valid.